Skip to main content

Troubleshooting

"Named point 'stage' does not exist"​

The cue uses @stage, but there is no point with that name. Create it first:

/sc point set stage

I don't see my laser or spot​

  • Beams only appear while a show is playing them. Start the show.
  • Beams are visible up to 50 blocks away. Move closer.
  • A beam needs a cue that gives it a location before on works. See Where the beam comes from.
  • Check the console for an error about GuardianBeam. That means your server version isn't supported yet.

My displays are gone after a restart​

That's on purpose. Displays are not saved with the world. Start the show again to bring them back.

A cue is skipped, and the console says "location is not available"​

The cue's world is not loaded, or its named point was deleted. Load the world or create the point again.

"A show can't start itself"​

A show start cue can't point to its own show. To repeat a show, use /sc start <show> loop.

"Animatronics is not installed"​

The animatronic trigger needs the Animatronics plugin.

A block turned into a redstone lamp​

A light cue points at a block that can't light up, so it was replaced by a lamp. Fix the coordinates of the cue.

The show is out of sync with the music​

  • Make sure every cue uses the same start time as your music cue (usually 0s).
  • Use live recording to place cues by ear, then fine-tune them with /sc gui.
  • Show time follows the real clock, so lag doesn't push the show out of sync. Lag can delay single cues a little.

Still stuck?​

Ask us in our Discord server.